Parts for Maytag MLE20PRBZW2: 12 - Pump And Motor Parts

Fixes washer that won't spin or agitate. Drive motor powers drum rotation during wash and spin cycles. Direct replacement for failed motors.

Panel mounting screw for laundry centers. Secures control panels, trim pieces, and access panels. Replace missing, stripped, or damaged screws.

Fix F20 error codes and water level issues with this washer air chamber. Connects to the pressure switch hose to regulate water fill. Easy DIY repair.

Fix a laundry center that won't start or runs intermittently. This motor wire harness restores electrical connection between motor and controls.

Secure dryer vent hose to exhaust outlet and wall connection. Replace worn clamps to prevent duct slippage and maintain proper airflow. Confirm fit.

Connects the outer tub to the drain pump in your washer. Replace if cracked, leaking, punctured, or worn. Includes check ball housing for proper drainage.

This hose clamp secures a hose connection to prevent leaks and keep your appliance running smoothly. It provides a tight, reliable hold on the hose fitting so water or air stays contained during operation.

• Tightens around a hose and fitting to maintain a secure seal
• Helps stop drips, seepage, or loose connections
• Common fix when you see moisture around a hose joint
• Useful if a clamp is rusted, stretched, or no longer holding tension

• Unplug power and shut off water (if applicable) before servicing
• Note clamp position/orientation before removal
• Use appropriate screwdriver or nut driver to tighten evenly
• Do not overtighten—ensure a snug, leak-free seal without damaging the hose

The Spring Tension Hose Clamp is an OEM part for Whirlpool washing machines. It is designed to secure hoses in place, preventing leaks by maintaining consistent tension on the hose connections.

Over time, spring tension hose clamps can lose their effectiveness due to metal fatigue, corrosion, or damage from frequent tightening and loosening. This can lead to leaks and improper hose connections.

Symptoms of a bad spring tension hose clamp include:

• Water leaks around hose connections
• Loose or disconnected hoses
• Unusual noises or vibrations during operation
• Water pressure issues within the washing machine

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Washer won't drain or spin? A failed water pump is often the cause. This pump circulates and drains water during wash cycles. DIY repair in 1-2 hours.

Replacement grommet for laundry center washers. Installs to cushion and protect components from vibration. Order now if yours is cracked or missing.

Cap for your washer. Installs on the control panel or cabinet to cover openings or secure components. Replace if cracked, broken, or missing.

Mounting screw for washer assembly. Secures components and panels in place. Replace if screw is stripped, missing, or no longer holds parts firmly.

Fixes water leaks, slow drainage, or cycle interruptions caused by a cracked or clogged inner outlet hose. Straightforward replacement restores flow.

Secures the drain hose to the washer cabinet or pump. Replace this retainer clip if it's broken, cracked, or missing to keep the hose properly attached.