Customer Questions and Answers for Control Board by Whirlpool

Hello Charles. On the model numer you provided, the motor ohms are 6-7.5 ohms and the two grey are 155-195 ohms. Thank You.

Hello Charles. If the motor reads 0 ohms, it is bad and needs to be replaced. Hope this helps.

Hello Charles. From black to white, and from brown to white, it should read 6-7.5 ohms. From grey to grey, you should read 155-195 ohms. Hope this helps.

Hello Charles. You will need to check and see if the motor WP22003856 is turning on the unit. If not, check the ohms of the motor. It should read around 6.2- 6.9 ohms. If it is bad, and the motor control board is new, you will need to replace the motor. Make sure all the connections on the unit are good, and no wires are broken on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Charles, Did you also run the board output test, and other tests ? Not all the codes you supplied are correct but, the LR code indicates the motor did not run, 05 indicates a continuous off balanced load,7F ? and OE is a water fill error, but does not apply to your machine ? Get the new board in and run the unit. Good Luck and Thanks

Hello Charles. No, the board WP22004257 will need to be replaced if it is bad. Hope this helps.

Hello Charles. Here is what the manufacture says to check for no spin. Hope this helps. Make sure the door lock light is on. If not, make sure the wax motor is locking the door. If it is not moving, check for power to the wax motor. If there is power, replace the wax motor. No power, replace the control board. If the door lock light does come on, make sure all the out of balance switches on the tub are good and the connections going to them are good. If so, you will need to replace the machine control board WP22004257. Hope this helps.

Hello Charles! The keypad is available with the console assembly 22003911. Thanks.

Charles, If you're sure you followed the programming instructions from the tech data sheet exactly, and it did not accept the program, you will need to circuit check the keypad ribbon, first. if the keypad ribbon tests OK, then replace the control board. Thanks and Good Luck

Hello Charles. You will need to look and see if there connector has markings on it. They should be A-, B-, C-, A+, B+, and C+. If so, test across A- to A+, B- to +, and C- to C+. Hope this helps.