Parts for Kitchenaid KFXS25RYWH2: 02 - Refrigerator Liner Parts

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

This replacement screw fastens appliance components securely in place. Use it to replace missing, stripped, or corroded hardware so panels, brackets, and covers stay aligned and rattle-free.

• Secures parts such as panels, brackets, covers, or internal assemblies
• Restores alignment and helps eliminate vibration or rattling from loose hardware
• Replaces lost, rusted, or damaged screws during service
• Maintains safe, stable operation by keeping components tight

• Disconnect power before service; if applicable, also shut off water and/or gas
• Start threads by hand to avoid cross-threading; tighten snugly without over-torquing
• Use the correct driver bit to prevent stripping the head

Clear light lens cover that protects and diffuses your refrigerator's interior bulb. Replace when cracked, yellowed, or missing to restore bright, even lighting and shield the bulb from spills.

This electronic control board is the appliance's central command module, managing power and timing to motors, valves, heaters, and sensors. Replacing a failed board restores consistent operation and responsive controls when the original becomes intermittent or unresponsive.

• Directs and times appliance operations based on user selections and sensor feedback
• Switches power to loads via relays/triacs to run motors, valves, heaters, and fans
• Monitors inputs and stores fault data; may trigger error codes or indicator lights
• Typical failure signs: won't start or run, dead/blank display, unresponsive controls, stops mid-cycle, random beeping/error codes

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Use ESD protection and handle the board by its edges to avoid static damage
• Photograph wiring and transfer connectors one at a time; ensure all locks are fully seated
• Follow the model's tech sheet/service manual for any required setup, diagnostics, or calibration after installation

Interior lights staying on or not working? This door switch controls refrigerator lighting and functions. Moderate DIY repair with video guide available.

Housing cover for bottom-mount refrigerators. Replaces cracked, broken, or missing plastic housing. Installs inside refrigerator compartment.

Replacement water filter cover for refrigerators. Snaps into place to protect and secure the water filter. Replace if cracked, broken, or latch damaged.

Replaces a cracked, broken, or missing upper water reservoir cover in your refrigerator. Keeps the water tank sealed and prevents spills into compartments.

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

Mounts the water filter base to the refrigerator cabinet. Replace this bracket if cracked, broken, or missing to keep the filter housing secure and aligned.

Stores and chills water inside the fresh-food section for steady dispenser flow. Replace this tank if cracked, leaking, or blocked to restore proper operation.

Bypass cap replaces water filter when filtration isn't needed. Install when using RO system or preferring unfiltered water. Confirm fit with your model.

Ice maker not making ice or water dispenser not working? This refrigerator water inlet valve controls water flow. Common DIY fix, 30-60 min install.

Ice maker wiring exposed or damaged? This wire cover shields the harness inside your freezer. Simple snap-in installation takes minutes to secure wiring.