Thermador Housing Or Cover

Keep your appliance's controls working reliably with this switch cover. It mounts over a switch to hold it in place and shield it from damage, helping ensure consistent actuation and long service life.

• Retains and protects a control/interlock switch within its housing
• Helps keep the switch aligned for reliable on/off detection
• Shields the switch from dust and incidental contact
• Cracked, loose, or missing cover can cause intermittent operation or no response when the control is pressed

• Disconnect power to the appliance before servicing
• Remove the necessary panel to access the switch; note wire positions/orientation
• Transfer any clips/screws from the old cover and seat the switch fully
• Secure wiring away from pinch points before reassembly

Replacement housing cover for microwaves and ovens. Closes and protects internal openings. Restores secure fit when original is cracked, missing, or warped.

Replacement lamp support cover for range hood light housing. Shields bulb and wiring from grease and moisture. Replaces cracked, broken, or missing covers.

Griddle cover for electric cooktops and ranges. Replaces cracked, broken, or missing covers. Protects griddle surface when not in use. Handle sold separately.

Replacement grease tray cover for ranges and cooktops. Covers the grease collection area to contain drips and spills. Needed when original is cracked or missing.

Protective cap that mounts over control switches on your range hood control panel. Replace if cracked, broken, or missing to keep switches properly aligned.

Protective boot that covers the capacitor terminal on your range hood. Replace if cracked, torn, or missing to shield connections from moisture and dirt.

Replace a cracked, chipped, or missing microwave turntable plate. This glass dish installs on the drive roller to restore the rotating cooking surface.

This replacement griddle can is the stamped inner pan that supports the griddle surface and collects/drains cooking grease. It restores a secure, properly shaped cooking surface so the griddle heats and drains as designed. What it does

• Replaces a dented, warped or corroded griddle pan that can interfere with even cooking
• Provides the molded surface and drainage channels that direct grease away from heating elements
• Helps reduce grease pooling that can cause excess smoke or flare-ups
• Restores proper fit and alignment of the griddle assembly in the cooktop cavity

• One griddle can (inner griddle pan)

• Disconnect power to the appliance and allow all surfaces to fully cool before beginning work
• Use gloves to avoid sharp edges on the metal pan and protect hands from grease
• Remove the griddle surface and any fasteners per the appliance service instructions; reinstall using OEM hardware
• Follow the appliance manufacturer's service manual for torque, alignment and testing procedures

Protective cover for the potentiometer switch on your gas cooktop. Installs over the control shaft to maintain knob alignment. Replace if cracked or missing.

Protective cover for the potentiometer switch on your cooktop. Replaces cracked, broken, or missing covers to restore a clean, finished appearance.

Rear panel for 30-inch ranges. Covers the back of the unit for a finished look. Replace if cracked, dented, rusted, or missing to restore appearance.

Replacement filter door cover for range hood. Installs over the filter compartment. Order if your original door is cracked, broken, or missing.