Thermador Valve

Leak was slow but becoming gradually worse. Pulled dishwasher out from under counter then visually inspected sump while it ran. As soon as the water got very hot, I could see the sump leaking where it meets the stainless pan. Searched for the correct sump gasket without success. Turns out that the gasket is built into the sump for this model. The built-in gasket is very narrow (under-engineered IMHO which is probably why it developed a leak). Thanks to Simon's excellent videos at... Read more

• overflowing

After first thinking I had a leak under my sink (dripping into my workshop in the basement), I quickly traced the source back to my Bosch dishwasher. I removed the bottom kick plate (phillips screwdriver) and could see a continuous drip from the Water Inlet Valve. Easy to see because the Water Inlet Valve is mounted in front. I shut off the power to the dishwasher at my breaker box and turned off the water to the dishwasher. First, I easily disconnected the power clip at the back of the Water... Read more

It finally gave E15 code, then after drying out the E15 code came back within 5 minutes of running. I dried out the base then I ran the dishwasher and observed water coming down the overflow chute after running only 5 minutes.There is a water inlet (clear water chamber on the side of the machine). It had some gunk inside that was stopping a black float shut-off from moving. I replaced the water inlet chamber. I also suspected the non return valve (also called a check valve). From the parts... Read more

• overflowing
• Noisy

Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more

Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more

• overflowing

This was not my first rodeo have repaired our appliances and those of our daughters for years, have ordered parts from this site several times. We had a cold spell in Texas, as you may have heard. We weathered it okay but left the dishwasher closed on one of the colder nights, woke up to water on the floor in the kitchen. Turned off the supply line, shut off the dishwasher power, bailed out the bottom, and mopped up. Had a fair idea of what the cause was, checked a few websites, watched some... Read more

Bought a Thermador PRSE48" dual fuel range from Craigslist really cheap because it didn't work. Did a little research and decided to overhaul most of the top (gas) end. For what I paid for it it was worth it and I'd have a good stove with new components. Replaced the griddle thermostat, ignition micro switches, ignition re-igniter box, installed fixing kit with 2 new potentiometers, both solenoids, and gas regulator. Had to replace 2 gas lines, all 4 jets, and one brass nut that were... Read more

We have a built-in KitchenAid KSSC42QKS02. Unlike the other Kitchenaid or Whirlpool refrigerators, our valve is located at the bottom and towards the front of the refrigerator. I actually preferred it to be located at the back like the others. It would've been easier to get to. We had to lower the fridge turning the screws(front of the lower panel), so it would sit on the rollers. Then we just simply roll the fridge out, turn off the supply valve, and install the newly bought valve inlet. It... Read more

Bacteria buildup in the venting assembly and drain hose. Replaced them and it's back to normal Read more

Replaced the defective float switch. Read more

• Leaking
• Ice maker dispenses too much ice
• Ice maker not making ice

My refrigerator/freezer has two water valves, I replaced both of them. Read more

1) Cleaned all sprayer arms. Many of the outlet holes were clogged with small debris (mostly small bits of food and a Jolly Rancher candy wrapper). 2) Removed circulation pump to clean impeller assembly. It was really clogged with stuff (more candy wrapper, shards of glass, a small metal screw). Luckily impeller fins were intact. 3) Re-assembled. Watch for some sharp edges when re-connecting sump well. 4) Performed three or so test wash cycles pulled out from under counter to make sure I had... Read more

Replaced solenoid Read more