Parts for Whirlpool WGD7600XW0: 01 - Top And Console Parts

This part is the control panel for a dryer unit. This part is essential for the operation of the appliance. The control panel houses all of the controls, which means it features all of the buttons and knobs to run the drying cycles and apply any settings.When the control panel goes bad, the buttons will not work. A visual inspection may result in finding disconnected or burnt wires if this part is faulty. This control panel features a variety of connected parts and pieces that are necessary to this component. Because of the electrical component to this part, it's important to unplug the machine from the outlet before attempting to repair or replace this part.This specific control panel is compatible with dryers that are manufactured by the Whirlpool brand. It is sold individually as a high-quality part. This part is also sourced straight from the manufacturer.

This control knob assembly replaces a worn or broken selector knob so you can set and change appliance functions with a secure fit and clear detents. It restores reliable manual control for common user settings. What it does:

• Fits onto the control shaft to select cycles, temperatures, or settings depending on your model
• Provides tactile detents and a firm grip for accurate selection
• Resolves symptoms like a loose, cracked, or spinning knob that won't engage settings
• Prevents slipping or intermittent control inputs caused by a damaged knob

• Disconnect power (unplug or shut off breaker) before handling control parts
• Often installs by aligning onto the control shaft and pushing on until seated; some models may use a retaining clip or screw
• Handle gently to avoid damaging the control shaft or surrounding panel

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

Complete wire harness assembly that routes power and control signals throughout your dryer. Replaces damaged, frayed, or burnt wiring harnesses.

Screw for control panel.

For mating terminal use [AP31136300].

Replacement mounting screw for dryer assembly. Used to secure internal components and panels. Order a new screw if original is stripped, lost, or damaged.

Self-drilling screw secures panels, brackets, and trim without pre-drilling. Replace missing or stripped screws during appliance repair or reassembly.

Secures dryer drum components and prevents rattling. Replace if broken or missing to restore quiet operation. Verify fit with your model number.

Dryer seal that prevents air leaks and maintains proper airflow. Replace if you notice excessive lint buildup or reduced drying efficiency. Verify fit with your model number before ordering.

Secures dryer wiring to the cabinet to prevent rubbing and interference. Replace if your wire retainer clip is broken, missing, or damaged.