Parts for Whirlpool YWED9150WW1: 01 - Top And Console Parts

White dryer top panel that covers the drum and internal components. Replace if cracked, damaged, rusty, or worn from heavy use or chemical spills.

Secures dryer wiring to the cabinet to prevent rubbing and interference. Replace if your wire retainer clip is broken, missing, or damaged.

Structural bracket that secures components inside your dryer. Replace if bracket is rusty, bent, broken, or missing to restore proper support and alignment.

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

For mating terminal use [AP31136300].

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This replacement control knob assembly restores a solid, accurate feel when selecting settings on your appliance. Replace cracked or stripped knobs to regain smooth control and a clean, like-new appearance.

• Interfaces with the control shaft so you can select functions and settings
• Common failure signs: cracked or broken knob, stripped insert, wobbly fit, falls off, hard to turn, or missing knob
• Restores proper grip and pointer alignment for accurate adjustments
• Direct replacement engineered to match the original fit and function

• Disconnect power and allow any hot surfaces to cool before servicing
• Pull the old knob straight off the control shaft; avoid prying on the control panel
• Align the shaft/keyed flat with the new knob and press firmly until fully seated
• Verify smooth operation through the full range of settings