Parts for Kitchenaid KSM3306XFP0: Base And Pedestal Unit Parts

Field assembly for stand mixers. Installs inside the motor housing. Replace if cracked, damaged, or causing electrical issues in your mixer.

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

Replacement power cord for stand mixers. Installs at the rear base to supply electricity. Order when your original cord is frayed, damaged, or missing.

Rubber foot for stand mixers. Installs at the base to provide stability. Replace if worn, cracked, missing, or damaged to prevent mixer movement.

The Idler Shaft Retaining Ring is an OEM replacement part for Whirlpool dryers. Also called an "E" ring, it is a sealing gasket positioned between the front and rear housing omponents. Maintaining an airtight seal prevents gas leakage and promotes efficient drying performance.  

Causes of a bad retaining ring commonly involve compression loss of the rubber gasket material over many years of heating cycles. Exposure to petroleum-based cleaners may prematurely deteriorate the seal as well.

Symptoms of a failed 'E' ring include: 

• Gas leaks emitting foul odors around seams or vents   
• Reduced heat conductivity hampering dryer functioning
• Moisture accumulation shortens fabric lifespan  
•  Drafts compromising indoor air quality and energy bills

This OEM Whirlpool replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore gas dryer models. 

Replace your cracked or damaged stand mixer bowl to securely hold ingredients during mixing, beating, and folding. Verify fit with your model number.

Flex edge beater for 3.5 quart tilt-head stand mixers. Scrapes bowl sides during mixing. Replace if worn, cracked, or damaged for optimal performance.

This 6 Wire Whip incorporates air into ingredients for fluffy whipped cream, perfect for frostings and cakes with whipped egg whites. Fits KitchenAid 3.5 Quart Tilt Head models KSM3306, KSM3311, KSM3316, KSM3317, 5KSM3310, 5KSM3311, 7KSM3311, 9KSM3311.

Coated C-dough hook attachment for stand mixers. Mixes and kneads yeast dough efficiently. Replace if worn, damaged, or missing. Top-rack dishwasher safe.