Need Help?
Call or text
Cracked or broken dishwasher handle? This door handle restores function. Requires removing inner door panel for installation. Video guide available.
In order to replace this, you must remove the "outer door". This service manual is a pretty good reference (page 37): http://members.msaworld.com/wp-content/uploads/sites/3/2017/02/2013-DW-Service-Manual.pdf Note that this specific dishwasher has 12 screws that need to be removed before the outer door can be separated. Once separated, don't even bother trying to push the broken handle out of the front as suggested. You will probably end up damaging the outer door. Instead, take some... Read more
Dishwasher won't drain or shows E24/E25 error? The drain pump removes water after each cycle. DIY-friendly repair with basic tools in under an hour.
Dishwasher died after 1 year and two weeks after purchase! The Bosch tech arrived and recommended replacing the drain pump (as well as cleaning the filter in vinegar). Ordered pump from APPros and it arrived THE NEXT DAY! Took out old one.... installed new one... and it worked! The new pump fit perfectly. Read more
Fix a dishwasher that won't fill with water or leaks when not in use. This water inlet valve controls water flow during the fill cycle. DIY repair.
Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more
Dispenser door won't open or stay closed? This dishwasher dispenser releases detergent and rinse aid at the right time. Moderate DIY repair.
Process was a bit more complicated than the videos I had watched online. Had to remove both front panel and control panel to get to soap dispenser. Removed wires to soap dispenser and rinse aide dispenser. Removed wire "harness" around the top and right side of dispenser. Pried back the clips to allow dispenser to be pushed out. It was helpful to have another person to hold the door open at this point. Bent clips back and reinstalled everything. New part works great. Read more
Lower dishrack assembly for dishwashers. Slides in and out for easy loading. Replace when cracked, rusted, or prongs are broken or missing.
Purchased a new rack and would have skipped reporting on it except that the new rack is superior to the old one. Easy to load, better silverware basket. It is so much better I bought a one for my mother (same dishwasher - lucky her!) before she even had a problem with the original. Read more
Fix dishwasher not draining or foul odors with a new check valve. Prevents dirty water backflow into clean dishes. DIY-friendly repair in 1-2 hours.
Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more
Replaces broken, cracked, or missing dishwasher rack roller wheels. Snaps onto upper or lower dish rack to restore smooth rolling on track rails.
Bought new wheel and the are easy to replace. Found why the brok and did a quick fix so it wont happen again. As the wheels age one will pull off then they all get weak and the rack will come off the track, To prevent this. you can put a plastic tie so the wheels cant fall off in the first place, The disign holds them in place with pressure from the plastic but the plastic ages and gets weak. A tie would have to actually break before the wheel can fall off. Read more
Fix a detergent dispenser that won't open or leaks rinse aid. Replaces the complete dispenser assembly. Moderate DIY repair with video guide.
Replaced dispenser Read more
Secures the tine row assembly inside your dishwasher rack. Replace this small plastic holder if it's broken, cracked, or missing to prevent wobbly tines.
I looked carefully at why this one row of tines might be wobbly and saw that the row of tines next to it was secured by these little plastic pieces that just seemed to snap on. So I Googled "parts for Bosch dishwashers" and Appliance Parts Pros popped up. I called the number on the website and the very nice person who worked on the phone asked for the serial number on the door of the dishwasher. Then I described what I needed. She identified it by my description. I ordered it, it arrived,... Read more
Prevents leaks around the lower dishwasher door edge. Replace if you see water pooling, torn rubber, or gaps. Confirm fit with your model number.
The symptom was suds and water on the floor at the left front of the dishwasher within the first five minutes of operation. Examination of the seal inside the door showed it was warped and pushed up into the door out of place. Once disassembled we found a tear in the seal, severe warping, and the material was sticky and slimy rather than flexible. I found a video of the disassembly that was very helpful. It is necessary to pull the dishwasher out of the cabinet but my installation had no top... Read more
If your dishwasher won't fill with water or makes thumping noises, the water inlet valve likely needs replacement. Moderate DIY repair from base.
This was not my first rodeo have repaired our appliances and those of our daughters for years, have ordered parts from this site several times. We had a cold spell in Texas, as you may have heard. We weathered it okay but left the dishwasher closed on one of the colder nights, woke up to water on the floor in the kitchen. Turned off the supply line, shut off the dishwasher power, bailed out the bottom, and mopped up. Had a fair idea of what the cause was, checked a few websites, watched some... Read more
Fix a rinse aid door that won't stay closed or causes leaks. This dishwasher dispenser door with gasket snaps on in minutes. Easy DIY repair.
Twist the old one out, insert tab, twist until other side snaps in. Easy as pie after watching the video! Read more
Support bracket that secures the microwave door handle. Installs inside the door panel. Replace if cracked, broken, or shattered from regular use.
Since I have already made this same repair twice (once on my own appliance and once on a neighbor's), I'm getting pretty adept at it! Here are the steps: 1. Remove microwave oven door. 2. Using a putty knife, gently pry out the black plastic outer bezel. 3. Remove two visible screws near the latches that secure the inner prongy metal frame. 4. Using a putty knife and/or screw driver, lever up the metal frame by releasing the small tabs on one or two sides - (this is the trickiest part of the... Read more
The Bake Igniter is an OEM part for Bosch wall ovens and ranges. Located at the bottom of the oven cavity, it generates the radiant heat needed to initiate the bake burners.
Causes of a bad bake igniter can include failure of the delicate calrod-style heating element from prolonged high-temperature exposure over time.
Symptoms of a bad bake igniter include:
This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.
Replaced the ignighter and gas safety valve. Have to remove knobs, front panel and grill housing to access these parts. Read more
The Handle Endcap is an OEM part for Bosch dishwashers. This component is designed to secure the end of the dishwasher handle, providing a finished look and ensuring the handle remains firmly attached. It plays a crucial role in the overall functionality and aesthetics of the dishwasher door.
You should replace this handle endcap if it becomes damaged or broken. Common causes of a bad handle endcap include regular wear and tear, accidental impact, or frequent use that leads to stress on the component.
Symptoms of a bad handle endcap include:
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
This part is stainless but also comes in different colors:
White: 00615350
Black: 00615353
Bisque: 00418631
I easily found the replacement part on the Appliance Parts Pros website and ordered (2), one for each end of the handle and yes it is the same part for either side. They showed up a few days later. I had seen a video of how to expose the handle screws behinf the door face. I backed out the appropriate (6) Torx screws and the front of the dishwasher door came right off exposing the handle screws. (Note: This model of dishwasher is well engineered as the door face is completely separated from the... Read more
Fix a dishwasher that won't drain or makes grinding noise during drain cycle. This pump removes dirty water from the tub. Easy 5-15 minute replacement.
This was a 5 min job after I watched a video on YouTube Any one can do this Read more