Parts for Husqvarna YTH2246-917289540: Electrical Parts

Deck spindle assembly that houses the blade mounting shaft on riding mowers. Bolts to the mower deck. Replace if housing is cracked, worn, or damaged.

This OEM part is a battery box for lawnmowers. The battery box is the protective plastic cover that goes over a lawnmower battery. Over time, a battery box can become cracked or damaged. If the battery box is no longer fully covering the battery or has deteriorated to the point where it is no longer performing its intended function, it will need to be replaced. Luckily, replacing a battery box is a simple process.To replace the battery box, start by making sure the mower ignition is in the off position. Once off, remove the positive and negative terminals using a bolt wrench. Once the connectors have been removed, lift the battery out of its position. Once it's been removed, remove the old battery box cover and set the battery inside the new box cover. Once fully covered, place the battery back in its place and resecure the positive and negative terminals.This genuine replacement part is sold individually and compatible with Husqvarna brand lawnmowers.

If your riding mower won't start unless the brake is engaged or starts in unsafe conditions, the interlock safety switch may have failed. Direct replacement.

Replace your lawn tractor's wire harness assembly if the engine won't start, electrical components fail, or wiring is damaged. Connects engine parts for proper operation.

Fix a riding mower that won't start or has no electrical power with this protective fuse. Simple 5-minute replacement prevents electrical damage.

Mower won't start unless seated? This seat safety switch prevents operation when the operator leaves the seat. Simple swap-out repair for most DIYers.

Mower won't start or starter doesn't engage? This ignition switch activates your riding mower's electrical system. Simple DIY repair in under 30 minutes.

The starter solenoid, also called a starter relay, is a low-amperage relay that completes the high-amperage connection between the starter motor and the battery when the ignition key is turned. The starter solenoid is needed to engage the starter motor. When the ignition is turned on, the battery sends a small electrical charge to the starter solenoid. The solenoid shuts a switch, so a more significant amount of current is sent to the starter motor. The starter motor shaft starts to rotate and engage the teeth of the flywheel. The flywheel then turns the crankshaft to put the engine in motion. A bad solenoid can deny the flow of electricity to the starter motor and prevent engine startup. However, other underlying problems may also exist. The battery may be in good condition, but the engine is not cranking, or clicking and grinding noises may come from the solenoid. These are signs that the starter solenoid should be replaced. This starter solenoid is for use in riding lawn tractors and zero-turn riding mowers. It is compatible with specific models from different brands, including Ariens, Craftsman, Dixon, Husqvarna, Hyper Tough, Jonsered, Murray, Poulan Pro, Redmax, and Snapper. It is a genuine OEM replacement part sourced directly from the manufacturer and is sold individually.

Indicator meter not displaying properly or reading incorrectly? Replace this meter to restore accurate monitoring of your mower's systems. Simple install.

This screw is a genuine Husqvarna part, sold individually. This screw can be used as a replacement part in a lawn mower or a snowblower. The purpose of the screw in a lawn mower or a snowblower is to serve as a fastening component.The screw in a lawn mower or a snowblower might need to be replaced if the screw is chipped away, eroded, dented, punctured, or scraped at some point within the typical lifespan of the appliance. The screw can also be lost or misplaced during the operation of the appliance, in which case the screw should be replaced by this genuine OEM replacement part.This component is a genuine OEM replacement part sourced directly from the manufacturer. It is sold individually. This screw is compatible with the following outdoor appliance brands: Husqvarna, Craftsman, Weed Eater, Poulan, Murray, Ariens, and Dixon.

If your riding mower won't start or has intermittent electrical issues, a faulty ignition harness may be the cause. This wiring component supplies power to the ignition system.

Fix a lawn tractor that won't start or shuts off unexpectedly with this clutch interlock safety switch. Simple repair to restore safe operation.