Parts for Frigidaire DWU4005DR2: 04 - Inner Door Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Secure dishwasher components with this #8 x 5/8" mounting screw. Replace lost, stripped, or corroded screws to properly fasten panels and parts.

Plastic cap cover for dishwasher components. Installs over internal parts to provide protection. Replace if cracked, broken, or missing. Direct fit.

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This genuine replacement screw secures panels and components on compatible Frigidaire appliances, helping restore proper fit and reduce vibration or loose parts for safe, quiet operation. What it does:

• Fastens panels, brackets, and small components to appliance chassis
• Restores secure attachment to eliminate rattling or gaps
• Helps maintain alignment of covers and control panels
• Prevents further wear caused by loose or missing hardware

• Use the correct screwdriver or driver bit to avoid stripping the head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Disconnect power before working near electrical components or wiring
• Replace all like-for-like for even fit

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.