Parts for Frigidaire DWU4005DR2: 07 - Motor Pump Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This retainer lever secures and positions a moving component inside the appliance so doors, trays, or assemblies operate correctly. Replacing a worn or broken lever restores proper engagement and prevents loose or misaligned parts. What it does:

• Holds and guides a mating part or linkage in place to ensure consistent engagement
• Prevents assemblies from slipping or coming out of position during use
• Helps restore normal opening/closing or indexing behavior when the original lever is cracked or broken
• Works as a direct-fit replacement where the factory lever has failed

• One retainer lever

• Install with power disconnected and any moving assemblies supported or restrained
• Inspect adjacent clips, pins, or fasteners and replace if damaged—only the listed lever ships
• Use basic hand tools; avoid forcing components—ensure correct alignment before fastening

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.