Kenmore / Sears Axle, Roller, Pulley Parts

Snaped off and snaped on. Read more

I was repairing my daughter's WDT730pahz0 Whirlpool dishwasher. The bottom dish rack set of wheels was very easy to install. The replacements for the upper set of wheels is different than the originals. In my opinion, the replacements are far superior to the original parts. The problem, as many have pointed out, is that there are no instructions on how to install the new parts. I worked for 15 minutes, attempting to put the pieces together and then install them on the dishrack. That was a... Read more

I ordered 1 assembly first and then another broke. so I ordered 2 more and replaced 2 more. The 4th was replaced last summer. I should have ordered 4 and replaced all when the 1st one failed. Read more

I have an LG dryer purchased in 2007. Model: DLE9577SM. It was squeaking at start-up and rumbling a little. Not knowing what parts I would actually need, I ordered rollers with/without assemblies, tensioner pulley-only, new belt. After viewing this video a couple of times, I attacked my machine which is located in the comfort of my garage. Lots of room to spread out. Nice. This disassembly went OK however because, I suspect, my machine is 13 years old, the removal of the control panel was... Read more

Disassembled dryer. Installed new belt, drum rollers, idler arm and blower. Read more

Ordered the part and snapped it on. Read more

Slide diswasher out to reach the two screws that hold rollers. Reverse prcess, all done. Read more

Main problem was worn bearings in the motor, which was replaced. Additional issues were worn pulley on tensioner and impeller slipping on motor shaft. Pulley was replaced and hose clamp was used to secure blower on shaft. Read more

Parts snapped into place very easily. Appliance Parts Pros have always delivered on the right part, timely delivery and videos to help. I wouldn't go anywhere else. Read more

I found my parts and ordered the six I needed, however I did not pick up on the difference from the front wheels to the rear wheels in the the descriptions. The rear wheels are narrower and I ordered all front wheels, six fronts instead of four front and two rear. I made it work by using the axle from the new wheel with two old narrow wheels. Read more

I ordered the parts and replaced them with new ones. Read more

Replaced rollers which were easy except i had to pull the dishwasher about half way out of the cabinet Read more

Ordered new wheel assembly, which came in about a day and a half. The broken assembly was on the left front so I only had to slide the dishwasher out just enough to expose the two mounting screws on the outside of machine.When you remove the old assm there are two rubber washers on the back side. If you didn't order new ones,remember to remove them from broken assembly and install them onto the new piece.Overall this is an easy fix and took about ten minutes including pulling the machine away... Read more

1, Removed roller tray front stoppers from each side. 2. Pulled out empty top rack from dishwasher. 3. Removed existing top rack roller. 4. Inserted new roller where old one was located. 5. Repeated for each roller. 6. Inserted top rack back into dishwasher. 7. Enjoyed using both racks again!! Read more

Replaced the right and left front upper dish rack wheels. The best part was I ordered the parts Monday and had them first thing Tuesday morning. Read more

I pulled the unit away from the wall and noticed black dust on the floor. Unplugged the unit, turned off the water. Removed back panel (about 10 screws with Torx heads) and noticed the belt was off, the drive pulley was loose and wobbling on the shaft, black dust all over the inside. Belt was worn along one side. Some grooves/damage in the outer drum casing around the pulley where it appeared the belt had rubbed. Removed the lower crossbar (2 more screws) to get better access to the drive... Read more