Kitchenaid Wall Oven Heating Element

Following the instructions that I received through the helpful research of the APP staff, I disconnected the power, disassembled the back of the oven, and accessed the hidden element. This involved bending parts of the sheet metal and cutting the insulation, so I was very apprehensive about doing this. Once I exposed the compartment that contains the element, I had difficulty extracting the old part and was really nervous about pulling hard to extract it - until I saw the damaged element. It... Read more

• Element will not heat

Not really a repair, just needed to update some parts that were worn out. Drip pans were perfect and I am so glad to have found them on this location. Read more

I ordered a replacement burner from AppliancePartsPros.com and replaced it using a u-tube video to find out how to do it. I took pictures of the wiring before I took it apart and then removed the burner element from the glass tom, but I left all the wires attached. I screwed the new element to the glass top and then one by one I unhooked each wire from the broken element and then hooked them each back onto the corresponding place on the new element. I used the digital pictures I took of the... Read more

Ordered new ones Read more

Easy. Pulled the two screws that hold the top in place. Then lift the top and slide it forward 4 inches. Reach in and disconnect the two wiring harnesses (Squeeze the sides to release). Lift the entire top off and place it upside down on the table. Remove the four screws that hold the metal panel to the top. Flip this panel upside down. From under the panel and release the three clips that hold the element in place. ***YOU NEED TO SAVE THESE CLIPS**** they do not come with the new... Read more

First, I just unscrewed all nuts that are holding the frame and all surface elements. Once all parts, surface elements, control switches, are loose from the original glass, I just moved all parts to the new glass. Due to the weight of the glass, all actions have to be done carefully as I broken one corner of the glass couple of years ago when I replaced one of the control switch. Read more

• Little to no heat when baking

Turned off 40 Amp breaker. Removed shelves from oven. Removed two screws in back panel holding element in place. Slowly pulled element free making sure wires stayed attached and not lost in oven insulation. Removed two wires from old element. Attached wires to new element. Pushed wires back into oven rear wall. Reinstalled the previously removed two screws. Turned on breaker. Total time less than 10 minutes. Read more

Need to open because no parts’ numbers can be identified through their website. But the rest “order and put in” are very easy steps. Will come back if I do need other parts Read more

Whirlpool convection oven. Access to convection element from inside. Three screws to remove plate covering fan blade. Then one screw to remove element bracket. I placed tape over the holes with the wires so they wouldn’t pull back into the panel. Remove old element at tabs and replace. Very easy fix. Removing door to oven made it easier to get to but not necessary. Read more

I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes. Read more

• Little to no heat when broiling

I am extremely happy to say that I ordered my replacement part from Appliance parts Pros.com. This is the 3rd time I have done business with them and like each time before I looked at a video they have showing how the repair is to be properly done. Best website hands down for appliance parts! Read more