Parts for Kenmore 790.76503510 (79076503510, 790 76503510): Main Top Parts

Replace your range's main top glass surface when it's cracked, chipped, or broken. This cooktop glass installs on the top of your range unit. Direct fit.

Medium burner drip pan installs under the heating element to catch spills. Replace when cracked, stained, or worn to restore your range's appearance.

Replace your cracked, broken, or missing range grate. This burner grate sits on top of your cooktop to support pots and pans during cooking.

This door gasket seals the refrigerator door to help keep cold air in and warm, humid air out—reducing frost build-up and helping the appliance run more efficiently. Fits where a full perimeter door seal is required. What it does:

• Creates an airtight seal around the refrigerator door to maintain consistent internal temperatures.
• Helps prevent warm air infiltration, moisture, and frost accumulation inside the compartment.
• Reduces energy waste caused by a failing or damaged door seal.
• Common symptoms of a bad seal: condensation at the door, frost on shelves, fluctuating temperatures, or higher energy use.

• Disconnect power to the appliance before attempting any service.
• Remove the old gasket carefully; replacement typically seats into the door channel around the full perimeter.
• Inspect and, if needed, adjust door alignment and hinge condition to ensure a proper seal.

Replacement grate foot kit for gas range burner grates. Includes 8 rubber feet and adhesive. Needed when feet are missing, cracked, melted, or worn.

This is a mounting bracket that secures internal components to the appliance chassis, helping maintain proper alignment and stable operation. It replaces damaged or bent brackets to restore secure support. What it does:

• Provides a secure mounting point for internal parts to prevent movement and rattling
• Restores proper alignment when a bracket is bent, cracked, or broken
• Helps reduce vibration-related noise from loose components
• Supports safe, reliable operation by keeping components fixed in place

• One mounting bracket

• Disconnect power to the appliance before starting any repair
• Use basic hand tools; avoid over-tightening fasteners which can strip threads or warp the bracket
• Handle edges carefully; brackets can have sharp metal edges

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.