Parts for Dacor EF42DBSS: Right Door Parts

Replacement hinge leaf assembly for refrigerator doors. Restores proper door alignment when original hinge is worn, damaged, or causing door sag.

Replaces a bent, worn, or damaged refrigerator door hinge. Restores smooth pivot action and proper door alignment for even gasket seal contact.

The Screw is an OEM part for Whirlpool refrigerators. This screw plays a small but important structural role, securely fastening the refrigerator door hinges in place.

Causes of a bad screw include normal wear and tear, repeated door opening/closing stress, or accidental damage during cleaning or servicing of the hinge area.

Symptoms of a bad hinge screw include:

• Loose or sagging door that does not close or seal properly
• Increased vibration or noise from the hinge area
• Difficulty opening/closing the door smoothly

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This is a direct replacement kit sold as a single pack to restore the original function of the listed Whirlpool assembly. It provides a like-for-like part so your appliance can operate as intended. What it does

• Replaces the failed factory component referenced by Use 2256389 / 2302878
• Restores the specific mechanical/electrical function of the original assembly
• Helps address common symptoms such as failure of the related cycle, intermittent operation, or no response from the affected subsystem
• Provides a one-for-one swap when the original part is damaged or worn

• One replacement kit

• Disconnect power and water before beginning any service
• Follow the original equipment manufacturer's instructions and use proper tools
• Handle electrical connectors and small parts carefully to avoid damage

Door storage bin for side-by-side refrigerators. Mounts inside the door to organize condiments and small items. Replace if cracked, broken, or missing.

Door storage bin for side-by-side refrigerators. Mounts inside the door to organize condiments and small items. Replace if cracked, broken, or missing.

Refrigerator door gasket seals the perimeter to keep cold air in and warm air out. Replace if worn, brittle, or loose. Confirm fit with your model.

Replace your refrigerator's support plate if it's cracked, broken, or missing. This mounting plate provides structural support for internal components.

Stainless steel screw that secures the back panel to the side panel of your dryer cabinet. Replace if screw is stripped, missing, or corroded.

Positions and supports the upper edge of your refrigerator door to maintain proper clearance and alignment. Replace if cracked, worn, or missing.

10-24 x 1/2 inch mounting screw for securing appliance panels, handles, brackets, and internal components. Replace lost, stripped, or damaged screws.

Left-hand endcap trim anchors the rail for refrigerator bins and shelves. Replace this bracket if cracked, broken, or missing to restore proper support.

Right-hand end cap that secures the refrigerator door bin trim. Replace this plastic trim piece if cracked, broken, or missing to restore a flush fit.

Cantilever door bin hooks into refrigerator door liner to hold bottles, jars, and condiments. Replace cracked, broken, or missing bins to restore storage.

Replacement door shelf bin for your refrigerator. Mounts inside the door to store gallons, condiments, and smaller items. Order when cracked or broken.

Secures the door shelf or bin to your refrigerator door. Replace this lever if it's cracked, broken, or missing to restore stable storage function.

Secures and releases refrigerator door shelf bins. Replaces worn, broken, or missing levers that lock door bins in position for safe storage.