Parts for Maytag MDB8969SDH0: 10 - Square Upper Rack And Track Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Replacement upper dishrack for dishwashers. Holds dishes, glasses, and utensils during wash cycles. Replace if rusted, cracked, or broken tines damage items.

Replacement right adjuster housing for dishwasher upper rack. Holds and supports the right side height adjustment mechanism. Replace if cracked or worn.

Replacement left adjuster housing for dishwasher upper rack. Restores proper rack alignment and stability. Needed when housing is cracked or broken.

Secures the dishwasher upper rack to the slide rail and allows height adjustment. Replace if the clip is cracked, broken, or won't snap onto the positioner.

Replacement upper rack adjuster for dishwashers. Mounts to the upper rack to adjust height and provide flexible loading. Replace if cracked or broken.

Rear adjuster guide for dishwasher upper racks. Enables smooth up/down adjustment to accommodate different dish sizes. Replace if broken or missing.

Clips onto the upper dishrack to hold the height adjuster assembly in place for balanced operation. Replace if cracked, broken, or missing.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

This small clip secures the guard/shield on the dispenser assembly. Replacing a cracked or missing clip keeps the guard firmly attached and aligned so the dispenser operates properly without interference, noise, or premature product loss. What it does:

• Fastens the dispenser guard to its mounting point on the dispenser assembly
• Keeps the guard aligned to prevent interference with dispenser door/flow
• Restores a secure fit if the original clip is cracked, deformed, or missing
• Common symptoms: loose or missing guard, rattling, incomplete dispensing or residue left after a cycle

• 1 dispenser guard clip

• Disconnect power to the appliance; turn off water supply if applicable
• Open access, support the guard, and release the worn clip from its tabs
• Snap the new clip fully into place, ensuring it engages all locking points
• Ensure the guard is secure and that the dispenser door/flow path is unobstructed before use

Adjuster cover for dishwasher upper rack height adjustment mechanism. Replace if cracked, broken, or missing to protect adjuster components from water.

Quantity of ONE. Size: 8-18 x 5/8 inch. (#8 screw, 18 threads per inch, 5/8 inch long)

Small retaining clip that secures trim, panels, or components in your dishwasher to prevent rattling or detachment. Replaces broken or missing clips.

This factory screw secures panels, brackets, or components within your appliance. Using the correct OEM fastener helps ensure a snug fit and prevents loosening, rattling, or misalignment over time.

• Fastens metal or plastic components to maintain proper alignment
• Helps prevent vibration, noise, and loosened parts
• Common wear item that can strip, rust, or go missing
• Replaces damaged or missing hardware to restore secure mounting

• Disconnect power and shut off water or gas before service
• Note original screw location and orientation for proper reassembly
• Start threads by hand to avoid cross-threading; do not overtighten
• If threads are damaged, inspect the mating hole or clip before reuse

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.