Washer Bracket & Flange

Mounting bracket secures washer or dryer to pedestal base. Replace if bracket is cracked, broken, or missing from a used pedestal purchase.

Stacking kit mounts your dryer securely on top of your washer to save floor space. Includes brackets and hardware. Replace if missing or damaged.

Mounting bracket secures components inside your laundry center. Replace if bent, broken, or missing to eliminate rattling and restore stability.

Secures internal components to the washer frame. Replace if your bracket is cracked, rusted, broken, or missing to restore stable support and alignment.

Secures washer panels and components to the cabinet. Replace if your mounting bracket is cracked, broken, or missing to restore proper alignment.

Mounting bracket secures internal components and panels in your washer. Replace if bracket is cracked, broken, or missing to restore proper alignment and support.

Secures internal washer components in proper alignment. Replace this mounting bracket if cracked, rusted, broken, or missing to restore stability.

Secures U-shaped drain hoses or heating elements in washers. Replace if cracked, broken, or missing to prevent hose movement and potential leaks.

Replacement mounting bracket that secures washer panels and components. Needed when original bracket is cracked, broken, or missing, causing loose or misaligned parts.

A stabilizer bracket that secures and supports internal components to reduce movement and rattle during operation. Helps restore stable alignment so the appliance runs quieter and more reliably. What it does:

• Provides structural support to help keep assemblies aligned and reduce excessive movement
• Dampens vibration and minimizes knocking or rattling noises tied to loose components
• Restores proper fit where a worn or broken bracket allowed shifting or misalignment
• Works as a repair for symptoms like intermittent noise, excess vibration, or parts that sag or shift

• Disconnect power (and water if appliance-specific) before beginning any repair
• Basic hand tools are usually required; refer to your model's service manual for exact steps
• Inspect surrounding parts for wear while replacing the bracket

Secures the washer door assembly to the cabinet frame. Replace if your original bracket is cracked, bent, or broken to restore proper door alignment.

This heat probe is the oven temperature sensor that senses internal oven temperature so the control can regulate heating for even cooking and accurate bake cycles. It replaces a failed or intermittent probe assembly. What it does:

• Detects oven cavity temperature and sends a signal to the range/oven control board
• Helps restore consistent baking and broiling temperatures when the original probe fails
• Can cause incorrect oven temperature readings, long preheat times, or uneven cooking when defective
• Works with the probe wiring and oven control to maintain set temperature

• Disconnect power to the appliance before replacing the probe to avoid shock
• Handle the sensor and lead wire carefully; avoid sharp bends or kinks in the cable
• Make sure the connector is fully seated and secure before restoring power

Spring mounting bracket for washers. Secures suspension springs to the washer tub or frame. Replace if bracket is cracked, bent, or broken from load stress.

Mounting bracket for dryer assemblies. Secures components in place during operation. Replace if bracket is bent, cracked, broken, or missing.

6-20 x 3/8 in. screw secures panels and brackets inside washers. Replaces missing, stripped, or damaged fasteners to restore proper fit and stability.

Corner bracket for washer structural support. Mounts in frame corner to secure components. Replace if cracked, bent, or broken during installation.