Parts for Whirlpool WFW95HEXL1: 06 - Pump Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Internal drain hose routes wastewater from the washer tub to the drain pump. Replace if cracked, torn, leaking, or damaged by wear or rodents.

Secure dryer vent hose to exhaust outlet and wall connection. Replace worn clamps to prevent duct slippage and maintain proper airflow. Confirm fit.

Drain hose for washing machines. Connects tub to pump to carry water during drain cycles. Replace if cracked, leaking, or damaged. Includes anti-siphon ball.

Secures water hoses to fittings and prevents leaks in your washer. Replace when connections loosen or clamps lose tension. Verify fit with your model.

The Spring Tension Hose Clamp is an OEM part for Whirlpool washing machines. It is designed to secure hoses in place, preventing leaks by maintaining consistent tension on the hose connections.

Over time, spring tension hose clamps can lose their effectiveness due to metal fatigue, corrosion, or damage from frequent tightening and loosening. This can lead to leaks and improper hose connections.

Symptoms of a bad spring tension hose clamp include:

• Water leaks around hose connections
• Loose or disconnected hoses
• Unusual noises or vibrations during operation
• Water pressure issues within the washing machine

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This dishwasher drain pump assembly actively removes wastewater from the tub and pushes it through the drain hose at the end of each cycle. Replacing a weak or failed pump restores proper draining and helps prevent standing water and odors.

• Pumps water out of the dishwasher during drain cycles and sends it through the drain hose to the sink/disposal
• Common symptoms: water left in the tub after a cycle
• Humming or buzzing from the pump with little/no water movement during drain
• Drains slowly, intermittently, or triggers a drain-related error
• Visible damage or a seized/broken impeller on the original pump

• Disconnect power and turn off water supply; protect the floor from spills
• Remove standing water and check the drain hose/sump for blockages before replacing the pump
• Access the pump from the base/front; release the lock (twist or tabs, per model) and transfer the wire connector
• Seat the new pump fully to seal; reconnect, then run a short cycle to check for leaks and proper draining

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Rubber grommet that seals where hoses pass through the washer cabinet. Replace if cracked, worn, or missing to prevent water leaks and damage.

Filters debris from washer drain pump to prevent clogs and drainage issues. Replace if water won't drain or you notice blockages. Confirm fit with model.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.