Refrigerator Switch

• Light not working

Well started with the bulb switch when that didn't work, i continue with the next switch which was the door switch, then it worked just make sure the light bulbs are good, because i went thru 4 bulbs Read more

Replaced faulty latch with new latch. New latch was different configuration, but the fit was okay. The only issue was that the wires to the electric motor were just barely long enough. Overall easy repair if you have a T15 Torx bit, phillips screwdriver, and 1/4" nut driver. Hardest part is removing the gas cooktop to gain access to the cleaning latch. 0. Turn off electric to stove; remove the cast iron grates, center caps/orifices, and catch pans from the stovetop. 1. Disconnect the... Read more

• Light not working

We actually were able to determine that one of the freezer switches was bad and taped it down for about 3 days. The beeping stopped. Our fridge has two freezer switches and one fridge side switch. I ordered all three from these guys. They were cheaper than Whirlpool by about $20 for parts and about $15 for shipping. The part numbers had superseded too many times to count, usually that doesn't matter but in this case it did. The new parts were just slightly bigger than the old parts AND... Read more

• Not dispensing water

I replaced the switch which was bad and also replaced the water inlet valve. Read more

Replaced the four-button switch assembly. Read more

APPs stellar videos got me started with confidence. Your parts diagram exactly match mine for my 28 year old Sears Kenmore Gas Model 110-97588210 (75882). Teacher at TMM Appliance convinced me to approach from the simpler, cheaper, easier to access parts inwards using the wiring diagram. I’ve designed products for Klein, Halo, and JUNO but am just an advanced electrical amateur. 3 parts totaling $110 and two hours and it runs and heats to spec. Even had time to vacuum out all over the lower... Read more

• Light not working
• Not dispensing water
• Ice maker not making ice

Turn the power off to the range. Pull off the black control knob. Remove 6 - 5/16 screws in back of the range behind the controls panel. Take out 2 screws (behind the control knob) in front that hold the control swirch in the panel. Remove each wire from the old switch and place it onto the new switch (one at a time)so get the wires are installed in the correct place. Make sure the wire are tight on the new switch. Install the new switch, put the two mounting screws in, reinstall the back, put... Read more

Purchased new evaporator/heater/sensor assembly from appliance parts. Removed new heater, sensor and wire harness from new assembly and from existing unit in refrig section. Then installed new heater and sensor on old refrig evaporator, avoiding complex soldering and recharge with Freon. Once repaired all failure indications cleared and refrigerator section performing like new. Also purchased new heater for water tank and several broken plastic parts that went in in 2 minutes. Changed door... Read more

Removed rocker switch,made up jumper so the compactor could be used while awaiting replacement switch. The part came 2 days later and was installed in less tha 5 minutes. Unit working like new again. Thanks for the great service!! Read more