Snow Removal Equipment Deflector & Chute

Replaces cracked or missing grass deflector shield on walk-behind mowers. Mounts at discharge chute to control clippings and debris direction.

Replacement chute assembly for snowblowers. Directs expelled snow away from equipment. Replace if cracked, damaged, detached, or missing from unit.

5-inch chute adapter for gas snowblowers. Connects the discharge chute assembly to direct snow flow. Replace if cracked, broken, or missing for secure fit.

This lower chute is a quality replacement part that is used on several models of snowblowers. It is made of high-quality plastic for durability and is placed so it can direct snow in a certain direction when it leaves a snowblower. Over time and with regular use, this part can become damaged. If this occurs, it will need to be replaced so the discharged snow ends up in the right location.When replacing the lower chute, a wrench and work gloves will be needed. The snowblower should be placed on a flat surface, and the spark plug wire needs to be disconnected. The gearbox and the lower chute will need to be removed before the new replacement part can be installed. Line up the chute and install it used the cotter pin and flange lock nut. Replace all the components before using the snowblower.This is an authentic OEM replacement part that is sourced directly from the manufacturer. It is sold on an individual basis. The lower chute is used with snowblowers manufactured by Craftsman, Cub Cadet, Huskee, MTD, Troy-Bilt, Yard Machines, and Yard-Man.

Chute adapter connects the auger housing to the lower chute on your snowblower. Replace if cracked, broken, or damaged to restore proper snow direction.

Lower chute assembly for snowblowers. Directs snow discharge from the impeller. Replace if cracked, broken, or missing for proper snow routing.

Lower chute ring for snowblowers. Secures the discharge chute assembly to the auger housing. Replace if cracked, broken, or missing for proper fit.

This genuine Husqvarna rear skirt provides protection from grass clippings and debris that could fly from underneath the lawn mower during use. Periodic inspection of the rear mower skirt for cracks and damage is an important safety measure for lawn mowers. Do not attempt to remove or install the rear skirt when the lawn mower is running. For models with clip-fasteners: Use a flathead screwdriver to remove the old skirt from the lawn mower. Line the new skirt up and reinstall the clips. For models with screw fasteners: Remove the screws holding the skirt in place, set screws aside for reuse. After removing the old rear skirt, clean the area to remove any dirt or debris. Flush installation is important in preventing debris flyout. Line the holes on the new skirt with the holes on the lawn mower. Reinstall screws and tighten. Dispose of the old skirt. The OEM skirt is made of high-quality, molded, composite black plastic. The unit is sold individually. This rear skirt does not include fastening clips or screws. Reuse fasteners on the current mower. This rear skirt compatible for use with Craftsman and Husqvarna push lawn mowers.

Plastic discharge chute for gas snowblowers. Directs expelled snow away from cleared path. Replace if cracked, broken, or damaged from impact.