Frigidaire Refrigerator Parts

• Door sweating

With no problem at all Read more

Ordered a new seal, and replaced it with a new one freezer works great now. Read more

• Door won't open or close

Ordered a new handle. Unscrewed two screws took the old handle off and put the new one on put the screws back in. It works great!! Read more

My frig is a year and a half old, Frigidaire with french doors and freezer drawer. It has an upper ice maker for the door in the frig and a bottom ice maker in the freezer drawer. After noticing the flood, I shut off the water supply to the frig and cleaned up the mess. Didn't know if it was the water solenoid valve that stuck open or if the bottom ice maker got stuck calling for water. This frig has 4 solenoid valves and according to the schematic, two valves are active any time water is... Read more

• Freezer not defrosting
• Fridge too warm
• Freezer section too warm

This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart. Read more

• Ice maker dispenses too little ice
• Touchpad does not respond
• Leaking

Replaced ice maker Read more

• Not dispensing water
• Leaking
• Ice maker not making ice

This was a tough fix because there were two causes to my problem - a stuck water valve and a bad ice maker. I first replaced the water valve, but that did not resolve the problem. Tested existing water valve and found that the valves were working properly. Returned the water valve - easy RMA process and no issues. Replaced the ice maker and problem solved. Read more

Change filter Read more

• Won't start
• Too warm
• Fridge too warm
• Freezer section too warm

In short - I replaced the evaporator fan motor and the evaporator fan blade. The Appliance Parts Pros website was extremely helpful to me. Here's how. 1. The site helped me identify that even though my Freezer says it's a Frigidaire, it's actually an Electrolux. 2. The site identified the potential screech causing parts. (I didn't take a chance, I bought all three) It was a worthwhile investment. My freezer is 20 years old so it deserved some help. 3. The site provided guidance videos (not... Read more

Ordered left and right side supports and they arrived in two days! It took me longer to get stuff out of the way in the fridge so I could take the shelf out than it did to actually swap out the side supports. Parts fit perfectly and quick easy repair. Read more

Pulled the old ones off, pushed the new ones on. Read more

Very easy Read more

Suspected it was the thermostat, since temperature stayed the same at multiple settings over a 24 hr period. There was only three components inside the freezer besides the evaporator, the fan was working, so I decided to just go ahead and replace the thermostat and defrost thermostat. Also replaced the defrost timer by the compressor, just to get all the old parts replaced with new. I had already replaced the compressor, so now I've pretty much have a new freezer. The new parts works great and... Read more

Easy : Pulled off old damaged gasket and pushed on new ones. No tools needed Read more

I had to purchase the whole glass and support for the drawer and throw out the old glass and everything but the support brackets from the original. Had to remove the support brackets from the original drawer support and install them on the new one. Easy job just a lot of wasted product for a small broken piece. Read more

I believe we had two problems. Our gasket was ripped in several places and our drain pan line was clogged. Therefore the water was frozen and backing up into the freezer. Replacing the gasket is an easy job and could possibly be done quickly enough that you don’t have to remove your freezer food items if you don’t discover additional problems during the process. The most time-consuming part is the approximately 40 screws that hold the freezer door shelf panel and gasket to the door itself. ... Read more