General Electric Spring Parts

Spring component for dishwasher vent assembly. Installs on vent mechanism to provide tension. Replace if spring is broken, worn, or missing.

Suspension spring for washer tub support system. Replaces broken, stretched, or missing springs that cause excessive drum movement or noise during cycles.

Replacement ball joint top for washer suspension systems. Connects suspension rod to tub. Replace if cracked, worn, or broken to restore stability.

Curved suspension spring for washers. Supports the drum and absorbs vibration. Replace if cracked, broken, or causing excessive movement during cycles.

Replacement lid spring for top-load washers. Installs on the left side to counterbalance and support the lid. Needed when original is broken or stretched.

Replacement lid spring for washers. Installs on the right side to support the lid assembly. Order a new spring if yours is broken, stretched, or missing.

This leg spring is the replacement spring used with the appliance's leg/leveling support to secure and stabilize the lower corner. It restores proper support and reduces tilting, rocking, or uneven leveling. What it does:

• Secures the leg or leveling assembly to the appliance chassis to maintain proper height and position
• Helps prevent excessive vibration, rocking, or uneven operation caused by a loose or broken spring
• Restores correct tension in the leg mounting hardware so the appliance sits level
• Common symptom: appliance leans, rocks, or has an unstable foot under load

• One leg spring

• Disconnect power and water before servicing and ensure the appliance is empty and stable
• Support the appliance with a jack or blocks to relieve weight from the leg before removing/installing the spring
• Use pliers and gloves to handle the spring; take care to avoid pinch points or sudden release of tension
• Verify leg alignment and level after installation and test stability before putting the appliance back into normal use