Parts for Kitchenaid KHWV01RSS0: 06 - Pump And Motor Parts, Optional Parts (Not Included) Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This motor control board is created for use with washing machines. It's located inside the washing machine, where users can change settings and start or stop the appliance. It is tasked with regulating how quickly the washer spins during a cycle. Wear and tear or damage can cause the motor control board to malfunction. This may make it impossible for the washer to agitate or spin. If this happens, a replacement will need to be made.To replace this part, start by unplugging the appliance. Once the area is safe, the bottom front panel should be removed. This will provide access to the original motor control board. Pull on the motor control board until the wires can be reached. The position of these components should be noted before taking out the part. Replace with a new motor control board and replace the wires.This motor control board is designed to fit washing machines made by Maytag, Whirlpool, Kenmore, and KitchenAid. This is an authentic OEM replacement part that is sourced directly from the manufacturer. It's sold as a single part.

Fixes F02 drain error codes and slow draining. This small ball creates a seal in the tub-to-pump hose to control water flow. Simple DIY replacement.

Secure dryer vent hose to exhaust outlet and wall connection. Replace worn clamps to prevent duct slippage and maintain proper airflow. Confirm fit.

Drain hose for washing machines. Connects tub to pump to carry water during drain cycles. Replace if cracked, leaking, or damaged. Includes anti-siphon ball.

The Hose Clamp is an OEM part for Whirlpool washing machines. This clamp secures the hose in place, ensuring a tight connection and preventing leaks during operation. It is essential for maintaining the integrity of the washing machine's water system, securing hoses that carry water to and from the washer.

Common causes of a bad hose clamp include rust, physical damage, or loosening from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Water leaks around the hose connection points
• The hose slipping off the fitting
• Visible rust or wear on the clamp
• Difficulty in tightening the clamp to secure the hose

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore models.

Hose clamp for securing water supply and drain hoses on the washer. Provides leak-free seal at hose connection points.

Rubber grommet that seals where hoses pass through the washer cabinet. Replace if cracked, worn, or missing to prevent water leaks and damage.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Pulley included.

Replacement mounting screw for washers. Secures panels, trim, and brackets. Needed when original screws are stripped, missing, or damaged during repairs.

Secures the drain hose to the washer cabinet or pump. Replace this retainer clip if it's broken, cracked, or missing to keep the hose properly attached.

Replacement drain hose for washing machines. Connects the drum to the drain outlet. Replace if cracked, split, leaking, or worn from rubbing against shocks.

Extends the drain hose approximately 4 feet. You must also order a drain hose connector kit: 285835.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.