Washer Dryer Combo Cable Or Retainer

This bushing protects the appliance service cord where it passes through the cabinet, reducing wear and preventing chafing that can expose wiring. It's a simple replacement that restores a safe cord entry point. What it does:

• Cushions and centers the service cord at the cabinet opening to prevent abrasion
• Helps keep the cord from rubbing on sharp metal edges that can cause insulation damage
• Reduces risk of shorting, sparking, or intermittent power caused by a worn cord
• Commonly replaced when the existing bushing is cracked, missing, or deformed

• One service cord bushing

• Disconnect power (unplug or switch off breaker) before servicing
• Inspect the cord and surrounding insulation; replace the cord if damage is found
• Push the bushing into the cabinet opening, then route the cord through the bushing until seated
• Reuse only if undamaged; do not force a damaged bushing into place

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Secures and routes the drain hose in your washer dryer combo. Replace if the original stop is cracked, broken, or missing to properly support the hose.

Harness cable tie secures and organizes wiring inside your appliance. Replace if damaged, cracked, or no longer holding wires firmly in place.

Spring retainer for washers and laundry centers. Secures internal springs in place. Replace if cracked, broken, or missing to restore proper assembly.

A small replacement clip that secures the dispenser hose to the dispenser assembly, helping keep the hose seated and reducing the chance of leaks or disconnection. Simple, durable part for restoring proper hose retention. What it does:

• Holds the dispenser/hose connection firmly in place to prevent the hose from slipping free
• Helps reduce water leaks and intermittent dispenser flow caused by a loose hose
• Keeps hose routing stable to avoid rubbing or wear against nearby components
• Works with the dispenser assembly to maintain proper alignment and seal

• One retainer as shown

• Disconnect power and water supply before starting any repair
• Access the dispenser area per your appliance's service instructions; remove trim or panels if required
• Snap the retainer over the hose at the dispenser connection until it seats; verify the hose is fully seated
• If you see damage to the hose or fittings, replace those parts before finishing

Secures the motor assembly in your washer. Replace this retainer if it's cracked, broken, or missing to properly mount and stabilize the motor housing.